Toro Flex-Force Power System 14in 60V MAX Mode D'emploi page 21

Adjusting the Cutting Swath
The trimmer comes from the factory with a cutting swath of 36.6 cm (14
inches) as shown in A of
adjust the swath to 40.6 cm (16 inches) as shown in D of
1. Remove the swath blade from the bottom of the guard by removing
the 2 screws holding it in place using the provided Allen wrench (B of
Figure 10) and rotate the swath blade 180°.
2. Once the swath blade is rotated, install it onto the guard using the 2
screws previously removed (C of
Figure 10. Refer to the following instructions to
Figure
Figure 10
19
Figure
10).
10.
g524941