Toro Flex-Force Power System 14in 60V MAX Mode D'emploi page 13

Setup
1
Connecting the Attachment to the Power Head
No Parts Required
Procedure
1. Install the square shaft of the attachment into the square shaft of
the power head (A of
2. Align the locking button on the lower shaft with the slotted hole on
the upper shaft and slide the 2 shafts together (B and C of
3. The locking button clicks into the slotted hole when the shafts are
secured (C of
4. Using the screw-handle, tighten the screw on the shaft connector
until it is secure (D of
Figure
Figure 3).
Figure
3).
3).
11
Figure 3).