Toro Flex-Force Power System 14in 60V MAX Mode D'emploi page 24

Replacing the String
Important:
Use only 2 mm (0.080 inch) diameter monofilament string
(the manufacturer Part No. 88611) or 2.4 mm (0.095 inch) diameter
twisted monofilament string (the manufacturer Part No. 88202).
1. Remove the battery pack and clean any debris from the trimmer
head.
2. Remove any old string on the spool by repetitively pressing the bump
button while pulling the line out equally from both sides of the trimmer.
3. Cut a piece of string according to the following specifications.
•
If you are using 2 mm (0.080 inch) string, cut one piece of line
approximately 4.9 m (16 ft).
•
If you are using 2.4 mm (0.095 inch) twisted string, cut one piece
of line approximately 3 m (10 ft).
Important:
do not exceed the recommended length as this could damage
the trimmer.
4. Press and turn the knob on the string head until arrow on the knob
aligns with arrow on the string head
5. Insert 1 end of the line at an angle into the
the line through the string head track until it comes out through the
eyelet on the other side. Pull the line though the string head until the
line outside the string is evenly divided on each side.
Important:
disassembled view shown for clarity.
6. Hold the string head in place with one hand. With your other hand,
rotate the knob in the direction shown by the arrows (clockwise).
7. Wind the line, leaving about 102 mm (4 inches) extending beyond
the eyelet on each side.
Do not use any other gauge or type of string, and
Do not disassemble the trimmer head;
(Figure 12).
LINE IN
22
eyelet and push