Publicité
1.
Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope your new device brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this device assumes no liability for
damage to the device or caused by the device arising
from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failure of the electrical system in the event of the
electrical regulations and VDE provisions 0100, DIN
57113 / VDE 0113 not being observed
Note:
Read the whole text of the operating manual before as-
sembly and commissioning.
This operating manual should help you to familiarise
yourself with your device and to use it for its intended
purpose.
The operating manual includes important instructions
for safe, proper and economic operation of the device,
for avoiding danger, for minimising repair costs and
downtimes, and for increasing the reliability and ex-
tending the service life of the device.
In addition to the safety instructions in this operating
manual, you must also observe the regulations appli-
cable to the operation of the device in your country.
Keep the operating manual at the device, in a plastic
sleeve, protected from dirt and moisture. They must be
read and carefully observed by all operating personnel
before starting the work.
The device may only be used by personnel who have
been trained to use it and who have been instructed
with respect to the associated hazards.
The required minimum age must be observed.
22 | GB
In addition to the safety instructions in this operating
manual and the separate regulations of your country,
the generally recognised technical rules relating to the
operation of such machines must also be observed.
We accept no liability for accidents or damage that
occur due to a failure to observe this manual and the
safety instructions.
2. Device description (Fig. 1)
1.
Transport handle
2.
ON/OFF switch
3.
Quick coupling (regulated compressed air)
4.
Safety valve
5.
Pressure vessel
6.
Foot
7.
Drain screw for condensate
8.
Wheel
9.
Cable holder
10. Pressure gauge (set pressure can be read off)
11. Pressure regulator
A. Hexagonal bolt
B.
Nut
C. Washer
D. Flange nut
3. Scope of delivery
• Compressor
• 2x wheels
• 1x foot
• Assembly material
• Operating manual
4. Proper use
The compressor is used to generate compressed air
for pneumatically powered tools that can be operated
with an air rate of up to 85 l/min. (e.g. tyre inflaters,
air blow guns, paint spray guns). Due to the limited air
flow rate, it is not possible to operate tools with a very
high compressed air consumption (e.g. orbital sanders,
straight grinders and impact screwdriver).
The compressor may only be operated in a dry and well
ventilated indoor space.
The machine may only be used in the intended manner.
Any use beyond this is improper. The user/operator, not
the manufacturer, is responsible for damages or inju-
ries of any type resulting from this.
www.scheppach.com
Publicité
