Télécharger Imprimer la page

Stadler Form Lukas PRO Mode D'emploi page 10

Publicité

15. If desired, it is possible to connect a drainage hose to the unit for per-
manent water drainage. In this case connect the hose (21) to the unit
through the hole in the back of the dehumidifier and place the end of
the drainage in a water outlet. Please make sure the end of the hose is
lower than the spout, otherwise the water will not drain and flooding
may occur.
16. For easy side movement of the unit there are hidden wheels (23) at-
tached. First, empty the tank completely. Now you can easily move the
dehumidifier to the desired location.
17. If the device is not used on a daily basis, switch it off by pressing the On/
Off button (4) and empty the water tank. Note: The device has a memory
function and saves the last selected setting when you switch off the
device and disconnect it from the power supply.
Replacement of the HEPA filter
The HEPA filter (18) cannot be cleaned and must be replaced after approx. 12
months. To replace the filter, switch off the device and remove the air inlet
filter (16) on the back. Remove the HEPA filter (18) and insert the new filter.
Then reattach the air inlet grid. The HEPA filter can be obtained from the
dealer where you purchased your Lukas Pro.
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance (4) and unplug the mains cable (2) from the socket.
• Attention: Never immerse the appliance in water (danger of short-cir-
cuit).
• For external cleaning, rub with a damp cloth and then dry thoroughly.
• Make sure that the air inlet (17) and air outlet (15) are cleaned regularly
to prevent the build-up of dust. The air inlet (17) and air outlet (15) can be
cleaned with a dry brush or a vacuum cleaner. The air inlet (17) is fitted
with an air inlet grille (16) which can be removed and cleaned with a damp
cloth.
• If you don't use the dehumidifier for some time, empty the water tank and
dry the unit fully before storing it in its original carton.
Repairs
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the warranty
lapses and all liability is refused.
• Never operate the appliance if the adaptor or plug is damaged, after it has
malfunctioned, if it has been dropped or has been damaged in any other
way (cracks/breaks in the casing).
• Do not push any object into the appliance.
• If the appliance is beyond repair, make it unusable immediately by cutting
through the cable and hand it in at the collection point provided for the
purpose.
• In the event of a repair, the following points must be observed before the
appliance is shipped or taken to the dealer: completely empty the water
in the appliance (water tray or water tank), and allow the appliance to dry
completely. Appliances containing residual water may be damaged during
transport, invalidating the warranty.

Publicité

loading