Oceanic OCEACLIM110W Guide D'utilisation page 57

LED display and error codes
• In
COOL
In FAN or DEHUMIDIFIER mode; it displays the current temperature.
• If "E1", "E2" or "E4" are displayed, it means the appliance is not working
properly and you must contact a qualified technician.
• If "FL" is displayed, it means that the water tank is full and you must empty
it.
Remark: Pressing UP and DOWN simultaneously converts the unit of
temperature between °C (Celsius) and °F (Fahrenheit). Note that °C is
displayed by default.
WATER TANK FULL:
The corresponding indicator lamp will flash and an alarm will buzz when the
water tank is full.
If in the middle of setting the delay time, your press this
button again, it cancels the setting.
3. Pressing it while the timer is running
It displays the remaining time based on the previously
set hours. You can change and reset the time by
selecting a new length of time by pressing the buttons
UP and DOWN. The value will blink 5 times then fix
and the count down will start again.
The timer is configured at 1-hour intervals, from 1 to 24
hours: Press the UP & DOWN arrows to adjust the length of
time. Each press increases or decreases the length by 1
hour, and when 24 hours is reached, it cycles back to 1.
Once the timer is set, its indicator lamp above the button
lights up.
mode, it displays the
56
selected temperature.