Oceanic OCEACLIM110W Guide D'utilisation page 56

storage. For details, please refer to "Out-of-season storage"
section). To cancel internal dehumidification, just press this
button again.
After setting the COOL, DEHUMIDIFIER or FAN mode, you
can also choose:
- The SWING option to enable or disable auto-swinging of
the air deflector.
- The SLEEP button to run silently the appliance.
SLEEP mode
Sleep mode has these features:
•
The fan runs in slow speed, so noise is quieter.
•
It can be used in all operating modes, COOL,
DEHUMIDIFYING or FAN.
Sleep can be activitated by:
- The remote control, or
- The control panel by press UP & TIMER simultaneously
This indicator lamp will switch on when the SLEEP mode is
employed.
TIMER
Setting the timer allows you to either:
1. Instruct the appliance to turn off after a pre-determined
length of time (while the appliance is on);
Or,
2. Instruct the appliance to operate after a pre-
determined length of time (while the appliance is off,
but connected to electricity)
The TIMER button carries 3 functionalities:
1. Pressing it for the first time
It enters the TIMER mode, you can now use the UP &
DOWN arrows to configure the delay time, while the
screen display blinks. Once the time is chosen, the
LED screen continues to blink 5 times. The time is
confirmed afterwards.
After setting the timer, you can proceed to set the
MODE (COOL, DEHUMIDIFY, FAN) or SPEED (FAST,
MODERATE, SLOW).
2. Pressing it again in TIMER mode setting (within the
5 blinks of the screen display)
55