Hach AS950 Installation Et Maintenance page 11

remaining bottles in increasing numbers in the direction shown by the label. Refer to
on page 12 for a diagram of necessary components.
Figure 5 Bottle number 1 installation
1 Bottle number 1 location (compact base)
2 Bottle number 1 location for 24 bottles
3 Bottle number 1 location for 8 bottles
4 Bottle number 1 location for 2 or 4 bottles
5 Retainer
4.4.4 Install multiple bottles
When multiple bottles are installed, a distributor arm moves the sample tube over each bottle.
Sample collection automatically stops when the specified number of samples have been collected.
1. Install the first sample bottle (number 1) below the label in the sampler base. Refer to
first bottle for multiple sample collections
2. Assemble the sample bottles as shown in
first bottle goes next to the bottle one indicator in the clockwise direction.
3. Put the bottle assembly in the sampler. For eight or more bottles, align the wires in the slots in the
bottom tray.
6 Elastic straps
7 Composite insulated base for 21 L (5.5 gal) bottle
8 Standard insulated base
9 Compact base
on page 10.
Figure 6. For eight or more bottles, make sure that the
Figure 6
Install the
English 11