Superuser Code - Renkforce 1359882 Notice D'emploi

e) Superuser Code
Important!
If you switch on the "Auto-Entry" function (see chapter 11. m), all codes must have the
same length (e.g. master code + superuser code + user codes 5 digits).
The superuser code is used to activate outputs #1 and #2 manually. It is entirely independent,
e.g., of time limitations or system locks.
The superuser code can also be used to activate output #1 permanently.
Programming the superuser code
• The code lock must be in programming mode; see chapter 11. b).
• Enter the programming code
• Enter the desired superuser code, e.g.
• Confirm your input with the
• The code lock emits two beeps; the superuser code is saved.
When a new superuser code is programmed, it will overwrite the previous code.
Deleting the superuser code
• The code lock must be in programming mode; see chapter 11. b).
• Enter the programming code
• Confirm your input with the
• The code lock emits two beeps; the superuser code is deleted.
Function 1: Activating/deactivating outputs #1 and #2/resetting timer
Enter the superuser code like a regular user code. The corresponding output is then activated
(or deactivated in toggle mode, or a timer reset; see chapter 11. i).
Example: The superuser code was programmed to be "6789":
.
button.
.
button.
Activate/deactivate/reset output #1
Activate/deactivate/reset output #2
.
81