Renkforce 1359882 Notice D'emploi page 112

Changing the master code (default factory setting "0000")
• Enter the programming code "01" and then the desired new master code (e.g. "1234"), and
push the crosshatch button to confirm.
• The code lock will emit two beeps to confirm.
The present master code (factory setting "0000") is overwritten and no longer valid. If
you leave the programming mode and restart it later, you need to use the new master
code "1234".
Saving transponder for access authorisation for user #1
Enter the following programming:
(a) (b)
(a) Output #1 is to be switched
(b) Access only via transponder
(c) Memory slot number "001" (output #1 can use: 000 - 999)
(d) Hold transponder in front of the sensor surface (distance < 2 cm)
(e) Save programming (code lock emits two beeps)
Saving the user code for access authorisation for user #2
Enter the following programming:
(a) (b)
(a) Output #1 is to be switched
(b) Access only via user code
(c) Memory slot number "002" (output #1 can use: 000 - 999)
(d) User code "8321"
(e) Save programming (code lock emits two beeps)
112
(Reading transponder)
(c)
(c) (d)
(d) (e)
(e)