Resetting All Programming; Programming Master Code - Renkforce 1359882 Notice D'emploi

c) Resetting All Programming
All present settings and programming can be deleted very easily with a special code.
The master code is retained.
Proceed as follows:
• The code lock must be in programming mode; see chapter 11. b).
• Enter the code
• Confirm your input with the
• The code lock emits two beeps; deletion starts. During deletion, the LED (1) at the upper left
of the code lock will flash very quickly (orange).
Deletion may take a few minutes.
• When deletion is complete, the lock will emit two beeps and the LED (1) is lit permanently again
(orange); programming mode is active.
• All settings and programming have been reset to factory settings now; the master code is,
however, retained.
d) Programming Master Code
Important!
If you switch on the "Auto-Entry" function (see chapter 11. m), all codes must have the
same length (e.g. master code + superuser code + user codes 5 digits).
The master code is only used to activate programming mode (see chapter 11. b). The master
code cannot switch either of the two outputs.
Proceed as follows:
• The code lock must be in programming mode; see chapter 11. b).
• Enter the programming code
• Enter the new master code, e.g.
• Confirm your input with the
• The code lock emits two beeps; the new master code has been saved.
Write down the new master code carefully. If you have forgotten the master code,
proceed as described in chapter 8. b) to start programming mode. Then programme a
new master code.
80
.
button.
.
.
button.