Renkforce 1359882 Notice D'emploi page 101

2. Example: Deleting the locking time
(a) (b)
(a) Start programming for the locking time
(b) Execute deletion (code lock emits two beeps)
3. Example: Pausing/resuming the locking time
The locking time function can be paused and resumed with the superuser code (e.g. if specific
persons are still allowed to be in the office at night, e.g. for maintenance work).
Example: The superuser code was programmed to be "6789":
The programmed start and end time is not influenced by pausing the locking time
function.
While the locking time function is paused, the left LED (1) will briefly flash red. The LED
also additionally flashes orange briefly as usual to display regular operation). The two
colours may overlap due to the slightly different flashing frequency.
4. Example: Opening output #1 with the superuser code
Output #1 can be activated with the superuser code at any time even during the locking time.
Example: The superuser code was programmed to be "6789":
Pausing the locking time function
Resuming the locking time function (same code as for pausing)
Activate output #1
101