Stihl MSA 160.0 C Notice D'emploi page 42

English
®
– Bluetooth interface (only for batteries with
)
– Data transmission protocol: Bluetooth
The mobile receiving devices must be com‐
patible with Bluetooth
support the Generic Access Profile (GAP).
– Frequency band: ISM band 2.4 GHz
– Radiated maximum transmission power:
1 mW
®
– Bluetooth signal range: maximum 33 ft.
(10 m). The signal range may vary depend‐
ing on ambient conditions and the perform‐
ance of the designated receiving device,
i.e., smartphone or tablet. The Bluetooth
range may be significantly limited when the
signal is transmitted through metallic barri‐
ers (e.g., walls, shelving units, etc.) or near
strong electromagnetic fields.
– Minimum mobile terminal device (e.g., tab‐
let, smartphone) system requirements:
Android or iOS (in current version or higher)
For a complete list of approximate charging
times, see www.stihl.com/charging-times.
For a complete list of approximate battery run‐
times, see www.stihl.com/battery-life.
®
Bluetooth
®
The Bluetooth word mark and logos are regis‐
tered trademarks owned by Bluetooth SIG, Inc.
These word mark/logos are used by STIHL
under license.
If the battery is equipped with a Bluetooth
face, local operating restrictions (in aircraft or
hospitals, for example) must be observed.
Other Trademarks
Apple and the Apple logo are trademarks of
Apple Inc., registered in the U.S. and other coun‐
tries.
App Store is a service mark of Apple Inc.
Google Play and the Google Play logo are trade‐
marks of Google Inc.
1
Rated capacity calculated pursuant to IEC 61960. Usable energy available to the operator will be
less.
2
The battery is marked with its stored energy as provided by the cell manufacturer. Usable energy
available to the operator will be less.
42
®
5.1.
®
Low Energy 5.0 and
®
®
inter‐
26.3 Chain Sprockets
The following chain sprockets are available for
this model chain saw:
MSA 160.0 C
– 7-tooth for 1/4" PICCO pitch
– Maximum chain speed: 16.3 m/s
MSA 200.0 C
– 6-tooth for 3/8" PICCO pitch
– Maximum chain speed: 21.0 m/s
MSA 220.0 C
– 6-tooth for 3/8" PICCO pitch
– Maximum chain speed: 23.3 m/s
26.4 Minimum Groove Depth of
Guide Bars
The minimum groove depth of a guide bar
depends on the pitch of the guide bar.
– Minimum groove depth for 1/4" PICCO pitch
guide bars : 0.157 in. (4 mm)
– Minimum groove depth for 3/8" PICCO pitch
guide bars: 0.197 in. (5 mm)
26.5 Depth Gauge Setting
The depth gauge setting of a saw chain depends
on the pitch of the chain.
– Depth gauge setting for 1/4" PICCO pitch
chains: 0.018 in. (0.45 mm)
– Depth gauge setting for 3/8" PICCO pitch
chains: 0.026 in. (0.65 mm)
26 Specifications
0458-024-8201-A