Viewing The Measurement Results; Displaying Roughness Parameters - Hexagon Tesa Rugosurf 90G Mode D'emploi

TESA-Rugosurf 90 G

18 VIEWING THE MEASUREMENT RESULTS

To view the measurement results, press this key
There are three viewing options available:
1 Parameters (according to chosen standard as well as selected parameters)
2 Profiles (roughness, waviness etc.)
3 Curves (Bearing [Abbott] curve etc.)
Depending on your selection under Displaying at measurement end (see section 10.3.1), the first page may look different
than the others. Scrolling through the pages is done by pressing the key
pop-up menu on your display.

18.1 Displaying roughness parameters

Selecting
Depending on your settings, your image may looks slightly different from those below.
allows you to view roughness parameters.
or enabling on top to get the
23