Removing The Door - Inventum IOM6072RK Manuel D'utilisation

5. In case of heavy dirt, clean the outside of the appliance with a mild detergent.
Note:
The cover of the door can become discolored or the glass inside the door can be dirty. You can
remove the cover for thorough cleaning. Refer to section
6. If necessary, clean the cover of the door and the glass inside the door. Use warm water and a mild cleaning
agent. Dry the cover after cleaning.
REMOVING THE GUIDE RACKS
1. Pull the guide rack (A) from the opening at the front of the appliance.
2. Pull the guide rack from the opening at the rear of the appliance.
3. Remove the guide racks.
4. After cleaning, install the guide racks again. Refer to section

REMOVING THE DOOR

Warning:
Risk of injury. Keep your hands away from the hinges.
1. Open the door (A) of the appliance.
Caution:
Do not use a sharp object to open the levers. This can cause damage to the appliance.
2. Open the levers (B) on each side of the door.
3. Close the door halfway.
4. Remove the door. Use both hands.
5. After cleaning, install the door again. Refer to section
INSTALLING THE DOOR
Warning:
Risk of injury. Keep your hands away from the hinges.
1. Carefully place the door (A) in the appliance.
Caution:
Make sure that the hinges are placed correctly. If the hinges are placed incorrectly, you cannot open
the door.
2. Open the door.
3. Close the levers (B) on each side of the door.
4. Close the door of the appliance.
36 • English
'Removing the cover of the door'
'Installing the guide racks'
'Installing the door'
.
.
(Figure 9)
.
(Figure 10)
(Figure 11)