Installation; Safety Instructions For Installation; Preparing For Installation; Installing The Appliance - Inventum IOM6072RK Manuel D'utilisation

Item
Down button
Clock button
4

Installation

SAFETY INSTRUCTIONS FOR INSTALLATION

• Safety during use can only be guaranteed if installation was done correctly and according to the instructions. The
installer is liable for damage caused by incorrect installation.
• The electrical installation must be carried out by a qualified electrician. The electrician must comply to national
and local regulations.
• The appliance has protection class I and may only be used in combination with an earthed connection.
• The appliance must be connected to a permanent installation in which provisions for switching off are integrated,
in accordance with the installation instructions.
• Make sure that the mains cable does not get jammed during installation or is running along sharp edges. The
mains cable must be placed in such a way that no contact is made with hot parts of the appliance.
• The connection point, mains socket and/or mains plug must always be accessible.
• The kitchen furniture in which the appliance is installed must be heat resistant to at least 90°C. This also applies
to the doors or front of the furniture.
• Make sure that the kitchen furniture in which the appliance is installed is firmly attached, for example by fastening
the furniture to adjacent elements.
• In case of incorrect installation or connection the warranty becomes invalid.
• Changes to the appliance, including replacing the mains cable, must be carried out by a certified installer.
• Make sure that there is sufficient ventilation and fresh air around the appliance.
UNPACKING
1. Remove the packaging.
Caution:
Make sure that you remove the sticker from the door.
2. Examine the appliance for damage.
3. Make sure that the voltage is the same as on the type plate.

PREPARING FOR INSTALLATION

(Figure 3)
(*) The minimum dimension for B1 is 585 mm and the maximum dimension is 595 mm.
Note:
Make sure that the kitchen furniture is prepared according to the dimensions of the appliance.

INSTALLING THE APPLIANCE

Preliminary requirements
1. Make sure that the kitchen furniture is prepared according to the correct dimensions.
30 • English
Function
To adjust the settings.
To set the clock or a set timer.