Installation; Safety Instructions For Installation - Inventum TK010 Manuel D'utilisation

Item
Function indicator
Oven indicator
Clock
Temperature indicator
Start/pause button
Lamp button
Temperature button
Clock button
Up button
Slider
Down button
Function button
Quick-preheat button
Delayed-start button
Timer/child-lock button
Cancel button
Note:
You can use both the up/down button or the slider to adjust the settings of the appliance. All three
buttons have the same function.
4

Installation

SAFETY INSTRUCTIONS FOR INSTALLATION

• Safety during use can only be guaranteed if installation was done correctly and according to the instructions. The
installer is liable for damage caused by incorrect installation.
• The electrical installation must be carried out by a qualified electrician. The electrician must comply to national
and local regulations.
• The appliance has protection class I and may only be used in combination with an earthed connection.
• The appliance must be connected to a permanent installation in which provisions for switching off are integrated,
in accordance with the installation instructions.
• Make sure that the mains cable does not get jammed during installation or is running along sharp edges. The
mains cable must be placed in such a way that no contact is made with hot parts of the appliance.
• The connection point, mains socket and/or mains plug must always be accessible.
• The kitchen furniture in which the appliance is installed must be heat resistant to at least 90°C. This also applies
to the doors or front of the furniture.
• Make sure that the kitchen furniture in which the appliance is installed is firmly attached, for example by fastening
the furniture to adjacent elements.
Function
To show the selected function (timer, quick preheat,
defrost, temperature sensor, delayed start, dough
proving, light).
To show the available and selected oven functions.
'Oven modes'
Refer to section
• To show the remaining time during operation.
• To show the current time when the appliance is off.
To show the selected temperature.
To start or pause the appliance.
To activate/deactivate the lamp inside the appliance.
To select the temperature.
To set the clock.
To adjust the settings.
To adjust the settings.
Touch and hold the slider to the left to decrease the
setting.
Touch and hold the slider to the right to increase the
setting.
To adjust the settings.
To select a function.
To select the quick-preheat function.
To select the delayed-start function.
To use the timer or to activate/deactivate the child lock.
To cancel a function or program.
.
English • 33