Prior To First Use; Installation - Inventum BV010 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3

prior to first use

Before using the appliance for the first time, you should proceed as follows: carefully unpack the cooker and remove all
packaging material and any promotional stickers. Keep the packaging (plastic bags, polystyrene and cardboard) out of the
reach of children. After unpacking the appliance, check it for external damage that may have occurred during transport.
Check that the voltage corresponds with what is stated on the information plate. For the installation of the cooker you must
observe the instructions in the INSTALLATION section.
Clean the cooker and all accessories with warm water and a mild cleaning agent. Properly rinse with water only and dry.
4

installation

• Safety during use is only guaranteed if the assembly has taken place in a technically correct way and in accordance with
these installation instructions. The installer is liable for damage caused by incorrect assembly.
• The cooker falls under protection factor I and may only be used in combination with an earthed connection.
The manufacturer is not liable for unsuitable operation and possible damage caused by unsuitable electric installations.
• The cooker must be connected to a permanent installation in which provisions for switching off are integrated,
in accordance with the installation instructions.
• Make sure that the power supply cable does not get jammed during installation or is running along sharp edges. It must be
placed in such a way that no contact is made with hot parts of the cooker.
• The connection point, socket and/or plug must always be accessible.
• In case of incorrect installation or connection, the warranty becomes invalid.
• Attention: any change to the appliance, including replacement of the power supply cable, must be performed by
a certified installer.
PLACEMENT OF THE COOKER
• The location of the cooker must be dry and properly aerated and have a properly functioning ventilation in accordance
with the applicable technical regulations. The suitability of the room for placement of a cooker is evaluated on the basis
of the following legal provisions.
• The room must be provided with a ventilation system. This installation should consist of a ventilation grille or a cooker
hood. Cooker hoods must be mounted in accordance with the included user manuals. The placement of the cooker
must guarantee free access to all control elements.
• If the cooker is used intensively and for long periods of time, it may be necessary to open a window to improve ventilation.
• The cooker must be placed on a hard, even surface (do not place on a frame).
• Before you start using the cooker, you must level it. This is particularly important for an even distribution of fat in the pan.
For this you can use the adjustable legs that can be reached when the sliding drawer is removed. Adjustment range � 5mm.
COOKER HOOD
min. 600 mm
33
English

Publicité

Table des Matières
loading

Table des Matières