Inventum BV010 Mode D'emploi page 29

• Only connect the appliance to alternate current, to an earthed
wall socket, with a mains voltage that corresponds with the
information provided on the information plate of the appliance.
• Safety during use is only guaranteed if the assembly has taken
place in a technically correct way and in accordance with these
installation instructions. The installer is liable for damage caused
by incorrect assembly.
• The gas connection must meet national and regional safety
instructions. That is why you should have the cooker connected
by a certified installer.
• The electrical connection may be carried out only by a qualified
electrician. This person should be aware of the national and
regional safety instructions with which the connection has
to comply.
• The cooker falls under protection factor I and may only be used
in combination with an earthed connection. The manufacturer is
not liable for unsuitable operation and possible damage caused
by unsuitable installations.
• The cooker must be connected to a permanent installation in
which provisions for switching off are integrated, in accordance
with the installation instructions.
• Make sure that the power supply cable does not get jammed
during installation or is running along sharp edges. It must be
placed in such a way that no contact is made with hot parts of
the cooker.
• The connection point, socket and/or plug must always be
accessible.
• In case of incorrect installation or connection, the warranty
becomes invalid.
• Attention: any change to the appliance, including replacement
of the power cable, must be performed by personnel of the
technical department who have been specifically trained.
• Never submerge the cord or plug in water.
• This appliance is only suitable for household use. If the
appliance is not used as intended, no compensation can be
claimed in case of defects or accidents and the warranty will
be invalidated.
29
English •