Prior To First Use; Setting The Clock - Inventum CM010 Mode D'emploi

3

prior to first use

Before using the microwave oven for the first time, please proceed as follows: carefully unpack the microwave oven and
remove all packaging material and any promotional stickers. Keep the packaging (plastic bags and cardboard) out of the
reach of children. After unpacking the appliance, check it for external damage that may have occurred during transport.
Check that the voltage corresponds with what is stated on the information plate. Prior to installing the appliance, observe
the instructions in section 8.
Clean the appliance and all accessories with warm water and a mild cleaning agent. Properly rinse with water only and dry.
Heat the empty microwave oven approximately 60 minutes to 230°C using the hot air mode
production residues, such as oil. In this way you prevent unpleasant odours from being generated when preparing food.
Ensure sufficient ventilation of the room.
• Press the on/off key
• Use the position button to select the hot air mode
selected. The standard setting of the temperature is 180°C.
• Press the key to adjust or confirm the temperature.
• Turn the adjusting knob
• Press the key and turn the adjusting knob
• Press the key to start the oven.
Allow the appliance to cool down after these 60 minutes and clean the interior once more with warm water and a mild
cleaning agent. Properly rinse with water only and dry.
4

setting the clock

When you insert the plug in the socket, 00:00 starts to flash and a sound signal can be heard.
• Turn the adjusting knob
• Press the key to confirm the time, once the correct time is set.
• To adjust the time, press the
• Turn the adjusting knob
• Press the key to confirm the time, once the correct time is set.
to activate the microwave oven
to change the temperature to 230°C.
to the left or right to set the correct time (24 hour clock).
key for approximately 3 seconds. The time flashes in the display.
to adjust the time.
. The symbol lights up in the display when the hot air mode is
to set the required time - 60 minutes.
to remove all remaining
25
English •