Inventum CM010 Mode D'emploi page 20

• Keep an eye on the appliance when heating food in a plastic or
paper container using the microwave mode. It could combust
spontaneously.
• In case of smoke, switch off the appliance and remove the plug
from the socket. Keep the door closed to smother the flames.
• Do not overcook food.
• Do not use the inside of the appliance as storage space. Do not
store any biscuits, bread, etc. in the appliance.
• Remove metal closing strips and metal grips of paper or plastic
containers/bags before placing them in the appliance.
• Always install the appliance in accordance with the instructions.
• Eggs in their shells and hard-boiled eggs should not be heated
using the microwave mode, as they could explode. Even after
the appliance has been switched off.
• Never clean the appliance with a high pressure cleaner or
steam cleaner.
• Do not place accessories of the appliance on the opened door.
• Never cover the oven bottom with aluminium foil. Aluminium
foil stops the heat and may therefore lead to poor baking
results. Moreover, the email of the oven bottom could get
damaged.
• The oven has a fan that cools the oven mantle. When the oven
is switched off, this fan could continue to run for some time.
• The contents of baby bottles and jars of baby food should be
stirred or shaken prior to consumption. Check the temperature
to prevent burns.
• Caution: Heating liquids could result in explosive boiling
over of the liquid. Also after the appliance has been switched
off. Be careful when removing the cup or container from the
appliance. Therefore, always place a plastic or ceramic spoon
in the cup when heating.
• This appliance may only be fitted by a certified installer.
• Defective parts may only be replaced by original parts. Only for
those parts will the manufacturer be able to guarantee that
they meet the safety requirements.
• Damage as a result of incorrect connection, incorrect fitting or
incorrect use does not fall under the warranty.
• If the connecting cable is damaged, it may only be replaced by
the manufacturer, its service organisation or similarly qualified
persons, in order to prevent hazardous situations.
• The electrical connection must meet national and local regulations.
20
• English