Installation Instructions - Inventum CM010 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8
installation instruction
• Safety during use is only guaranteed if the assembly has taken place in a technically correct way and in accordance with
these installation instructions. The installer is liable for damage caused by incorrect assembly.
• The electrical connection may be carried out only by a qualified electrician. This person should be aware of the national
and regional safety instructions with which the connection has to comply.
• The microwave oven falls under protective class I and may only be used in combination with an earthed connection.
The manufacturer is not liable for unsuitable operation and possible damage caused by unsuitable electric installations.
• The microwave oven must be connected to a permanent installation in which provisions for switching off are integrated,
in accordance with the installation instructions.
• Make sure that the power supply cable does not get jammed during installation or is running along sharp edges. It must be
placed in such a way that no contact is made with hot parts of the microwave oven.
• The connection point, socket and/or plug must always be accessible.
• The kitchen furniture in which the microwave oven is built, must be heat resistant (> 90°C).
• Check that the kitchen furniture in which the microwave oven will be mounted is firmly attached. For example,
by screwing it to the adjacent elements.
• In case of incorrect installation or connection, the warranty becomes invalid.
• Attention: any change to the appliance, including replacement of the power supply cable, must be performed by
a certified installer.
OVERALL DIMENSIONS
The figures below show the dimensions of the recesses in mm.
31
English

Publicité

Table des Matières
loading

Table des Matières