Technical Data - Inventum CM010 Mode D'emploi

ELECTRICAL CONNECTION
The mains voltage must correspond with the voltage shown on the information plate in the appliance.
In the meter cupboard, the groups must each be protected with a 16 Ampere fuse at least. The connection cable must have
a core cross section of at least 2.5 mm² and a length of 1.5 m. If the cable is too short, you cannot connect the appliance and
place it against the wall before you want to insert the plug in the socket.
BUILDING IN THE MICROWAVE OVEN
• Check that the kitchen furniture and recess meet the set requirements in relation
to dimensions.
• Slide the microwave oven in the kitchen furniture. Check that the base unit does
not make contact with the walls of the kitchen furniture. Make sure there is a space
of at least 2 mm between the base unit and the walls of the kitchen furniture.
Make sure the microwave oven is in a central position between the walls of the
kitchen furniture. Caution: make sure that the connection cable does not get
jammed and does not lie on top of the appliance.
• Open the door of the appliance.
• Use the provided screws to fasten the appliance to the side walls of the kitchen
furniture.
• The opening between the cabinet and the top of the microwave oven should not
be closed. This opening is needed for ventilation.
• Close the door of the appliance and insert the plug in the socket.
• The microwave oven is now ready to be used.

technical data

Connection voltage
Connected load
Microwave power
Ampere
Oven capacity
Diameter rotating platform
External dimensions without handle
Nett weight
32
• English
230 V ~50Hz
3350W
900W
15A
44 L
Ø 360 mm
595 x 568 x 454 mm (WxDxH)
Approximately 36 kg