Connecting The Appliance - Inventum IOM6072RK Manuel D'utilisation

Warning:
Two persons are required to install the appliance.
Caution:
Make sure that the mains cable does not get jammed during installation or is placed on top of the
appliance.
Caution:
Do not cover the opening between the kitchen furniture and the top of the appliance. The opening is
required for ventilation.
Note:
It is possible to connect the appliance to the mains supply before positioning the appliance.
Procedure
1. Put the appliance (A) in the center of the kitchen furniture.
Caution:
Make sure that there is a minimum space of 2 mm between the appliance and the walls of the kitchen
furniture.
2. Open the door (E) of the appliance.
3. Place the appliance in the kitchen furniture.
4. Install the plugs (B).
5. Fasten the appliance to the kitchen furniture. Use the screws (D).
6. Install the covers (C).
7. Close the door.
8. Connect the appliance. Refer to section

CONNECTING THE APPLIANCE

1. Make sure that the voltage in your home corresponds with the voltage of the appliance.
2. Make sure that the electrical system in your home is supplied with a 16 Amp fuse.
3. Use the supplied mains cable to connect the appliance to the mains socket.
After connecting, the clock shows '0:00', and the clock icon will flash on the display. Touch any button to quit.
REPLACING THE MAINS CABLE
If necessary, you can replace the supplied mains cable with a longer or different mains cable.
Warning:
Replacing the mains cable must be carried out by a qualified person.
Note:
Make sure that the new mains cable has a minimum core cross section of 1.5 mm2 and a length of 1 m.
If you use a mains cable that is too short, you cannot connect the appliance and position it in the kitchen
furniture before connecting the appliance to the mains socket.
1. Find the terminal box at the rear of the appliance.
2. Carefully push the pins (B) to open the cover (A). Use a screwdriver.
3. Remove the screws (C).
4. Place the new mains cable (D) in the terminal box.
5. Connect the wires according to the wiring diagram.
6. Install the screws.
7. Close the cover.
'Connecting the appliance' .
(Figure 4)
(Figure 5)
English • 31