Operation; Preparing For Operation; Setting The Clock - Inventum IOM6072RK Manuel D'utilisation

5

Operation

PREPARING FOR OPERATION

1. Remove the accessories from the appliance.
2. Clean the appliance and the accessories. Use warm water and a mild cleaning agent.
3. Rinse the appliance and the accessories thoroughly with water.
4. Dry the appliance and the accessories.
5. Use the oven for 60 minutes with a temperature of 250°C to remove any production residues, such as oil and to
prevent bad smells. Refer to section
Warning:
Make sure that the room is properly ventilated.
6. Let the appliance cool down.
7. Clean the appliance again. Use warm water and a mild cleaning agent.
8. Rinse the appliance thoroughly with water.
9. Dry the appliance.
10. Install the guide racks. Refer to section
INSTALLING THE GUIDE RACKS
1. Identify the guide racks for the left side (A) and the right side (B).
2. Push the guide rack (C) in the opening at the rear of the appliance.
3. Push the guide rack in the opening at the front of the appliance.

SETTING THE CLOCK

Note:
This procedure is valid for setting the clock and adjusting the clock.
1. Touch the clock button to select the clock function. The clock icon will flash.
2. Touch the up button or the down button to adjust the time.
Touch the buttons one time to increase the time per second or hold the buttons for 3 seconds to increase the time
faster.
Note:
The range is 24 hours.
Note:
If there is no operation within 5 seconds, the current time will be displayed and the clock icon goes off.
32 • English
'Using the oven'
.
'Installing the guide racks'
.
(Figure 6)
(Figure 7)