Publicité
Les langues disponibles
Les langues disponibles
exhaust and other parts will get hot. Thus, do not touch parts that emanate heat, as these may burn you.
Fault
Loud while running, ma-
chine vibrates heavily
Engine does not start
Engine overheating.
Machine does not drive.
Engine runs unsteadily
Poor cut, lawn turns
yellow after mowing.
The discharge of grass
clippings is unclean
The mower does not
start with the electrical
start
Motor output drops dur-
ing mowing
Braking power insuf-
ficient
Possible cause
• Screws are loose
• Blade fasteners are loose
• Blade is unbalanced
• V-belt damaged.
• Discharge chute blocked.
• Incorrect start sequence
• Choke setting incorrect
• Brake lever not pressed
• Speed lever in wrong position
• Spark plug is defective
• Fuel tank is empty
• Bowden cables too long
• poor fuel, storage without empty-
ing the petrol tank, incorrect
petrol type
• spark plug fouled (carbon residue
on the electrodes), electrode
distance too large
• The spark plug is wet from the
petrol (motor flooded).
• Engine faulty
• Dirty cooling ribs.
• Engine oil level too low.
• V-belt worn.
• Gearbox disengaged.
• V-belt (gearbox) detached.
• V-belt (gearbox) worn or defec-
tive.
• Missing feather key between rear
axle and rear wheels.
• Air filter is soiled
• Spark plug is soiled
• Blade is blunt
• Cutting height is too low
• Cutting height is too low
• Blade is worn
• Basket is clogged
• Chute blocked
• Grass too wet
• Driving speed too high
• Battery has discharged
• Fuse burnt out
• The driving speed in relation to
the cutting height is too high
• The brake is no longer set cor-
rectly
www.scheppach.com
Remedy
• Check screws
• Check blade fasteners
• Replace blade
• Replace V-belt.
• Clean discharge chute.
• Check start process
• Check choke setting
• Press brake lever
• Check setting
• Replace spark plug
• Refill with fuel
• Adjust the Bowden cables using the union nuts.
• Empty the fuel tank and carburettor. Fill with fresh
fuel.
• Clean the plug, check the heat value of the plug,
replace the spark plug as required, set to 0.6 - 0.8
mm
• Dry the spark plug and insert it again.
• Contact authorised customer service
• Clean cooling ribs.
• Check the engine oil level and top up the engine oil
if necessary.
• Replace the V-belt.
• Engage the gearbox (freewheel lever).
• Fit V-belt (gearbox).
• Replace V-belt (gearbox).
• Install feather key.
• Clean the air filter
• Clean the spark plug
• Sharpen the blade
• Set correct height
• Set correct height
• Replace the blade
• Empty the basket
• Clean the ejector chute
• Mow during dry weather
• Choose a lower gear
• Charge the battery
• Replace the fuse
• Reduce the driving speed and increase the cutting
height
• Contact the specialist merchant/customer service
GB | 55
Publicité
