Publicité
Les langues disponibles
Les langues disponibles
FILLING THE RINSING AGENT RESERVOIR
Rinsing agent is used to prevent traces of water drops on clean dishes and boosts the drying performance.
Careful:
Only use rinsing agent that is suitable for dishwashers.
Note:
Fill the rinsing agent reservoir when the rinsing agent indicator on the control panel lights up.
1. Open the rinsing agent reservoir (A). See figure 13.
2. Fill the reservoir (B) with rinsing agent up to the 'MAX' level. See figure 14.
13
A
Careful: Immediately remove spilled rinsing agent. Spilled rinsing agent could cause extreme foam formation,
which could lead to leaks.
SETTING THE RINSING AGENT CONSUMPTION
If water stains are formed on your items after a washing cycle, you must increase the rinsing agent consumption.
If blue stains are formed on your items after a washing cycle, you must decrease the rinsing agent consumption.
Set the rinsing agent consumption in accordance with information in the following section Rinsing agent
consumption settings.
Note:
By default, the rinsing agent consumption of the appliance is set to level 4.
1. Ensure that the appliance is off.
2. Press the on/off button to start the appliance.
3. Immediately press the programme selection Up button and hold it for 5 seconds until all indicators on the control panel
have flashed twice.
After this, the programme step indicators show the last set rinsing agent consumption level.
4. Press the programme selection Up or Down button to change the rinsing agent consumption level.
5. Press the on/off button to confirm the setting and switch off the appliance.
RINSING AGENT CONSUMPTION SETTINGS
Level
Number of rinsing agent doses
1
No rinsing agent is released
2
1 dose
3
2 doses
4
3 doses
5
4 doses
6
35-50
14
B
Indicator on
Programme step indicator Washing
Programme step indicator Drying
Programme step indicator End
Programme step indicators Washing and Drying
Programme step indicators Washing and End
Programme step indicators Drying and End
35
English
•
Publicité
