Fitting The Chuck - Pro-Point 8740144 Manuel D'utilisation

8740144
2.3 Insert the ends of the bolt into the magnetic assembly
(#14) and hand-tighten them.
3. Push the guard (D) down, then retract the arbor (E) until
the two grub screws (#7) at the top are accessible.
4. Lay the drill on its side.
5. Insert the arbor through the bearing bracket.
6. Loosen the grub screws. Push the arbor over the arbor
spindle (#8.6), aligning the screws with the spindle's flat
surfaces. Tighten the screws.
7. Follow Care & Maintenance – Slide Adjustment step 8 to
see if the slide needs adjustment. Tighten the hex head tap
bolts if no adjustment is needed. Follow all the steps in
Slide Adjustment if the bearing bracket oscillates

FITTING THE CHUCK

A drill chuck with adaptor is included to allow the use of a drill
bit instead of a cutting bit. This requires the removal of the
guard.
1. Push the guard (D) down, then retract the arbor (E) until
the two grub screws (#7) at the top are accessible.
2. Lay the drill on its side.
3. Loosen both grub screws several turns. Remove the arbor
through the bearing bracket (#12) and store in the case.
4. Loosen and remove both hex head tap bolts (#17), elastic
washers (#16) and flat washers (#15).
5. Remove the bearing bracket and bearing bracket spacer
(#13). Store in the case along with hardware removed in
step 4.
6. Loosen the grub screws in the drill chuck adapter (#69).
7. Slide the adapter over the spindle, making sure the grub
screws align with the spindle's flat surfaces.
16
MAGNETIC DRILL
For technical questions call 1-800-665-8685
V1.0