Ensure The Cutting Bit Shank Size Matches The Tool's - Pro-Point 8740144 Manuel D'utilisation

8740144
also fail to penetrate the material as the point may move
around under pressure, damaging the workpiece.

9.1 Ensure the cutting bit shank size matches the tool's

chuck or collet size.
9.2 Tighten the chuck or collet so the shank is tightly held
with no room to move.
10. Do not place the tool down after use until the bit has come
to a complete stop.
11. Do not touch the bit or workpiece surface cut with this
tool. They may be hot and could inflict a burn injury.
12. Always place the guard over the cutter before applying
power to the drill. The cutting bit could shatter under load
and cause a serious injury to you or bystanders.
13. Do not operate the drill if a metal slug is not released when
cutting is complete. The slug is jammed and could be
forcibly ejected, causing an injury to you or bystanders. It
may also damage the drill. See Operation - Releasing the
Slug to correct this issue.
KICKBACK PRECAUTIONS
Kickback is a sudden reaction to a pinched or snagged cutting
accessory caught on the material. The material can be ejected
and inflict a serious injury on the user or a bystander. Kickback
can also damage the tool or workpiece.
Kickback can be avoided by taking proper precautions:
1. Maintain a firm grip on the material and position your body
and arms to allow you to resist a kickback. Kickback can
propel the material in the direction of the cutting
accessory's rotation.
2. Use special care when working on corners, sharp edges or
flexible material. These workpieces have a tendency to
snag the cutting accessory.
3. Only use cutting accessories designed for the tool.
12
MAGNETIC DRILL
For technical questions call 1-800-665-8685
V1.0