PRO-POINT 8740144 Manuel D'utilisation page 10

8740144
5. Do not allow people, mobile equipment or vehicles to pass
over unprotected power cords.
5.1 Position power cords away from traffic areas.
5.2 Place cords in reinforced conduits.
5.3 Place planks on either side of the power cord to create
a protective trench.
6. Do not the wrap cord around the tool as the sharp edges
may cut the insulation or cause cracks, if wound too tight.
Gently coil the cord and either hang it on a hook or fasten
with a device to keep the cord together during storage.
POWER TOOL PRECAUTIONS
1. Do not use the tool if the switch does not turn it ON or
OFF. Any tool that cannot be controlled with the switch is
dangerous and must be repaired.
2. Do not allow the tool to run without a load for an extended
period of time, as this will shorten its life.
3. Do not cover the air vents. Proper cooling of the motor is
necessary to ensure normal life of the tool.
4. Avoid unintentional starts. Ensure the switch is OFF when
connecting to the power source.
5. Disconnect the power source before installing or servicing
the tool.
6. After making adjustments, make sure that any adjustment
devices are securely tightened.
7. Remove adjusting keys or switches before turning the tool
on. A wrench or a key that is left attached to a rotating part
of the tool may result in personal injury.
8. Do not touch an operating motor. Motors can operate at
high temperatures and can cause a burn injury.
9. Only use accessories that are specifically designed for use
with the tool. Ensure the accessory is tightly installed.
10. Never point the tool towards yourself.
10
MAGNETIC DRILL
For technical questions call 1-800-665-8685
V1.0