Troubleshooting; Disposal - DS Produkte XJ-14409B0 Mode D'emploi

EN

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself. If the problem cannot be solved with the steps that are listed, contact the
customer service department.
Do not attempt to repair an electrical device yourself!
Problem
The device does
not work.
The fuse in the fuse
box is triggered.
The device
switches itself off
automatically.

Disposal

Dispose of the packaging material in an environmentally friendly manner so that
it can be recycled.
This device is governed by the European Directive 2012/19/EU on waste electri-
cal and electronic equipment (WEEE). Do not dispose of this device as normal
domestic waste, but rather in an environmentally friendly manner via an offi cially
approved waste disposal company.
All rights reserved.
01496_04788_DE-EN-FR-NL_A5_V2.indb 20 01496_04788_DE-EN-FR-NL_A5_V2.indb 20
20
Possible cause
The mains plug is not inserted
correctly in the plug socket.
The plug socket is defective.
There is no mains voltage.
The device is overloaded /
has overheated. The device
is equipped with overload and
overheating protection; the
device switches off if it is over-
loaded or overheats.
Too many devices connected
to the same circuit.
The device is overloaded /
has overheated. The device
is equipped with overload and
overheating protection; the
device switches off if it is over-
loaded or overheats.
Fix
Correct the fi t of the mains
plug.
Try another plug
socket.
Check the fuse of the mains
connection.
Switch off the device, pull the
mains plug out of the plug
socket and allow the device
to cool down for approx. 10
minutes. The device is then
ready to be used again.
Reduce the number of devic-
es in the circuit.
Switch off the device, pull the
mains plug out of the plug
socket and allow the device
to cool down for approx. 10
minutes. The device is then
ready to be used again.
27.12.2019 13:55:36 27.12.2019 13:55:36