Gima PC-300 Manuel De L'utilisateur page 75

75
same place for over two hours, change the measurement site periodically and when neces-
sary.
 Do NOT place the SpO
 When the ambient temperature is over 35°C, please change the measuring site every two
hours; when the ambient temperature is over 37°C, please do NOT use the SpO
using in high temperatures can cause burns.
 Do NOT put the SpO
sure measurement may affect the SpO
 The device is calibrated to display functional oxygen saturation.
 Do NOT allow the sensor cable to twist or bend.
 Check the SpO
2
 When the temperature of the SpO
 Remove nail polisher or other cosmetic products from the fingernail.
 The fingernail should be of normal length.
 The SpO sensor cannot be immersed into water, liquid or cleanser.
2
 The SpO sensor can be repeatedly used. Please clean and disinfect before reuse.
2
 The SpO sensor can be repeatedly used. Please clean and disinfect before reuse.
2
 Anemia or low hemoglobin concentrations, intravascular dyes, carboxyhemoglobin, methe-
moglobin, and dysfunctional hemoglobin may effect the SpO
such situation, do not rely on the measured result for diagnostic decision, and it's recommen-
ded for the patient to consult with the doctor.
☞ PORT1 or PORT2 can be connected with either temperature probe, smart SpO
Easy ECG Monitor, but not any other devices or probes. Do NOT connect two probes or
devices with the same type (e.g. two temperature probes, or two smart SpO
Easy ECG Monitors) to both PORT1 and PORT2.
probe on a finger with edema or fragile tissue.
2
probe and pressure cuff on the same limb, otherwise the blood pres-
2
sensor and cable before use. Do NOT use a damaged SpO
sensor is abnormal, do not use it further.
2
measurement.
2
ENGLISH
sensor.
2
accuracy. If the patient has
2
probes, or two
2
sensor, as
2
probe, or
2