Maintenance; Maintenance Schedule - Husqvarna 540i XP Manuel D'utilisation

2. Figure out where the point of maximum tension is.
3. Examine which is the safest procedure to release
the tension.
Note:
In some situations the only safe procedure
is to use a winch and not your product.
4. Keep a position where the tree or branch can not
hit you when the tension is released.
5. Make one or more cuts of sufficient depth
necessary to decrease the tension. Cut at or near
the point of maximum tension. Make the tree or
branch break at the point of maximum tension.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.

Maintenance schedule

WARNING:
before you do maintenance.

Maintenance

Clean the external parts of the product.
Make sure that the power trigger and the power trigger lockout function cor-
rectly from a safety point of view.
1065 - 005 - 29.06.2020
Maintenance
Read and understand the
Remove the battery
WARNING:
through a tree or branch that is in
tension.
WARNING:
you cut a tree that is in tension. There
is a risk that the tree moves quickly
before or after you cut it. Serious injury
can occur if you are in an incorrect
position or if you cut incorrectly.
6. If you must cut across tree/branch, make 2 to 3
cuts, 1 in. apart and with a depth of 2 in.
7. Continue to cut more into the tree until the tree/
branch bends and the tension is released.
8. Cut the tree/branch from the opposite side of the
bend, after the tension is released.
The following is a list of the maintenance steps that
you must do on the product. See
25 for more information.
Do not cut straight
Be very careful when
Maintenance on page
Before
Weekly Monthly
use
X
X
25