Husqvarna 540i XP Manuel D'utilisation page 20

2. Apply full power and rotate the product. Keep the
spiked bumper against the trunk. This procedure
makes it easier to apply the force necessary to cut
through the trunk.
To cut a trunk on the ground
1. Cut through the trunk on the pull stroke. Keep full
power but be prepared for sudden accidents.
WARNING:
saw chain does not touch the ground
when you complete the kerf.
2. Cut approximately ⅔ through the trunk and then
stop. Turn the trunk and cut from the opposite side.
To cut a trunk that has support on one end
WARNING:
does not break during cutting. Obey the
instructions below.
1. Cut on the push stroke approximately ⅓ through
the trunk.
20
Make sure that the
Make sure that the trunk
2. Cut through the trunk on the pull stroke until the
two kerfs touch.
To cut a trunk that has support on two ends
WARNING:
chain does not get caught in the trunk
during cutting. Obey the instructions below.
1. Cut on the pull stroke approximately ⅓ through the
trunk.
2. Cut through the remaining part of the trunk on the
push stroke to complete the cut.
WARNING:
chain gets caught in the trunk. Use a lever
to open up the kerf and remove the
product. Do not try to pull the product out
by hand. This can result in injury when the
product suddenly breaks free.
To use the limbing technique
Note:
For thick branches, use the cutting technique.
To use the cutting technique on page 19 .
Refer to
WARNING:
risk when you use the limbing technique.
Kickback information on page 17
Refer to
for instructions how to prevent kickback.
WARNING:
careful when you remove small limbs and
do not cut bushes or many small limbs at
the same time. Small limbs can get caught
Make sure that the saw
Stop the motor if the saw
There is a high accident
Cut limbs one by one. Be
1065 - 005 - 29.06.2020