Light Signals - Philips Saeco XSMALL Sup 033R Mode D'emploi

CONTROL PANEL LIGHTS

Light Signals

Steady on
Slow blinking
Blinking fast
Slow blinking
Steady on
Steady on
Steady on
Blinking fast
Blinking lento
+
Blinking in counter-
clockwise direction (cyclical)
Alternating
blinking
+
Blinking
simultaneously
Causes
The machine has reached the right temperature and
is now ready:
- For coff ee brewing;
- For hot water dispensing;
- For steam dispensing
The machine is warming up to brew coffee and
dispense hot water or steam.
Machine is overheating. Coff ee may not be brewed.
Indicates that the machine is programming the
amount of coff ee to brew (see section "Adjusting the
Brewed Coff ee").
The machine is brewing a double coff ee
Low water level.
The coff ee bean hopper is empty.
Coff ee grounds drawer full
The water circuit is empty.
No brew group - No coff ee grounds drawer
Service door open - Knob in WRONG position for
machine operation.
The machine is performing the rinse/self-cleaning
cycle
A fault has occurred in the brew group.
A fault has occurred in the machine and hot water,
steam or coff ee cannot be dispensed.
• 26 •
Solutions
The water must be drained into a container by turning the
selector switch clockwise to the
ready temperature light
dispensing water.
Fill the water tank with fresh drinking water. After refi lling the water
tank, the indicator light turns off .
Fill the hopper with coff ee beans and start the procedure again.
With the machine turned on, empty the coff ee grounds drawer.
This operation is always required every 8 coff ees dispensed.
If the drawer is emptied before the signal is given the counter
won't be reset.
Fill the tank with fresh drinking water and prime the water circuit as
described in Section "Using the Machine for the First Time".
Make sure that all components have been correctly inserted and
closed. The blinking red light will now turn off .
The machine ends the cycle automatically.
You can interrupt the cycle by pressing either coff ee button.
Try again to brew another coff ee.
Turn the machine off . After 30-seconds, turn it back on.
Try this 2 or 3 times.
If the machine does NOT start, contact an authorised service centre.
" "
position until the green
" "
stays constantly on. After that, stop