Overview Of The Power Tool; Operating The Power Tool - Maxx-world 06656 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN

Overview of the Power Tool

1
12
11
10
9

Operating the Power Tool

PLEASE NOTE!
When not using the power tool and before inserting or removing a bit into / from the
bit receptacle, always move the rotation direction changeover switch to the middle
position. This locks the operating switch and prevents the power tool from being
switched on accidentally.
Do not overtighten screws so that neither they nor the workpiece are damaged.
Do not overload the power tool! Do not attempt to tighten a screw with force in order
to avoid damage to the power tool and to the bit.
NOTE: The rechargeable battery is supplied partially charged. To guarantee the full pow-
er of the battery, fully charge up the battery before you fi rst use it (see the "Charging Up
the Battery" chapter).
Adjusting the Handle for an Offset or Baton Screwdriver
Press the release button (3), keep it held down and rotate the handle (6) by 180°.
2
8
7
1.
180 °
2.
22
1 Bit barrel
2 LED charge status indicator
(green, yellow and red LED)
3 Release button for adjusting the
handle for an offset or baton
3
screwdriver
4 On/Off button for the LED light
5 Rotation direction changeover
switch
4
6 Handle
5
7 Charging socket
8 Operating switch
6
9 LED light
10 Ring of a bit
11 Shank of a bit
12 Bit receptacle

Publicité

Table des Matières
loading

Table des Matières