Technical Parameters - Samba DSD EVOLU 7 GSM Guide D'utilisation

GSM Signal Checking
Before installing the main unit, you should check the signal of the
installing place in order to ensure the unit can perform well. In setup
state, input [81]  #, the main unit will make a long beep and display
00+XX (XX indicates the intensity of the signal). And the intensity
should be within the range of 07-31; if it's less than 07, you should
change place.
For example: if the signal intensity is 12, it will display as:

Note:
Only under Out Arm status, the system has the function of sending SMS
alert for power failure/ power recovery. While in Disarm or Home Arm
status, it does not.
The SMS content:
Power failure: Power changer off
Power recovery: Power changer on

Technical Parameters


List 1:
Input Voltage
Standby Current
DC12V/1A
<55mA
64