Enter Settings; Exit Settings; Factory Reset; Coding Of Remote Controller - Samba DSD EVOLU 7 GSM Guide D'utilisation



Enter Settings

In the state of disarm, input 4-digit password by the keypad on the main
unit and press [#] button to confirm. You will hear a voice prompt: please
enter instruction. At the same time, [SET] indicator is on without flashing
and [0000] displays on the screen, indicating the system enters setting
status. You can perform different settings repeatedly as long as the system
keeps in setting status. The system will exit setting mode and return to
disarm status if you don't press any keypad button for 40 seconds.
Note：In setting status，press
The system default password is [8888].
Operating method: [XXXX][#]
X indicates the new 4-digit password.
LCD display:


Exit Settings

Press [*] and [#] buttons, the main unit emits a long beep and exits
settings. The [SET] indicator goes out and the system returns to disarm
state.
Operating method: 【*】【#】]


Factory Reset

In disarm status, use keypad to input [95175308246] and press [#] to
confirm, all the LED indicators will be on for 2 seconds and you will
hear a long beep. The main unit gets all its settings cleared and restores
to its factory settings successfully.
Operating method: [95175308246] + [#]


Coding of Remote Controller

The remote controller has to be code to the alarm host in order to
perform normally.
In setup state, use keypad to input [20], input the remote controller
can delete the numbers input.
52