Delete Remote Controller; Coding Of Defense Zone - Samba DSD EVOLU 7 GSM Guide D'utilisation

number [1~8], and then press [#] to confirm. The main unit emits a long
beep and you will hear "remote control coding". The [
on without flashing; press any button on the wireless remote controller,
the main unit makes a long beep and you will hear "coding completed",
[ ] indicator goes out, indicating the remote controller succeeds in
coding.
Operating method: [20]  [A]  [#]
A indicates：1~8 remote controllers number. You can add maximum 8
remote controllers.
LCD display:


Delete Remote Controller

The remote controller can't control the main unit after it's deleted.
In setup state, use keypad to input [21], then input the remote controller
number [1-8], and then press [#] to confirm. The main unit emits a long
beep and the [Signal] indicator flickers once. You will hear a voice
prompt "delete completed".
Operating method: [21]  [A]  [#]
A indicates：1~8 remote controllers number.


Coding of Defense Zone

Wireless detectors have to be coded to the main unit in order to trigger it
alarm.
In setup state, use keypad to input [23], input the defense zone number
you want to code [01~99], and then input [#] to confirm. The main unit
emits a long beep and the corresponding defense zone is displayed on the
screen. You will hear a voice prompt "detector coding". Then trigger a
wireless detector to emit a wireless signal; after receiving the signal, the
main unit makes a long beep, and you will hear "coding completed", the
[ ] indicator goes out at the same time.
Operating method: [23]  [XX]  [#]
XX indicates: 01 ~99 defense zones number
LCD display:
53
] indicator is