Timely Disarm; Timing Control; Alarm Number Setting - Samba DSD EVOLU 7 GSM Guide D'utilisation

2 Timely Disarm

In setup status, use keypad to input [36~38], then input the hour [AA] and
minute [BB] of the time you want to set to disarm, and finally input [#] to
confirm. You will hear a long beep and a voice prompt "setting
completed".
Operating method: [XX][AA][BB][#]
XX indicates: the address code 36, 37, 38 of the timely disarming
AA indicates: the hour of the setting time
BB indicates: the minute of the setting time
For example: set the arm time as 55' 7am
Operating method: [33][22][45][#]
LCD display:

3 Timing Control

In setup status, use keypad to input [39], then input the number indicating
turning on timely arm/ disarm [1/0], and then input [#] to confirm. You
will hear a long beep and a voice prompt "setting completed". The factory
default is off.
Operating method: [39][0/1][#]
0: turn off the function of timely arm/ disarm
1: turn on the function of timely arm/ disarm
For example: turn on the function of timely arm/ disarm
Operating method: [39][1][#]


Alarm Number Setting

In setup state, input [51] ~ [56], then input the voice alarm-receiving
number (mobile number or telephone number), and then press [#] to
confirm. The main unit will make a long beep, the [Signal] indicator will
flicker once, and you will hear "setting completed", which indicate voice
alarm-receiving number is set successfully.
Operating method: [XX]  [YY...YY]  [#]
56