B) The input alarm number must be valid, add necessary zone code (or country
code), or access permission code for extension phone.
C) The latest setup would replace the original one.
3.4.2 Delete alarm phone number
Format:
[*] + [#] + [1(2-6)]
Example:
[*] + [#] + [2]
Remark: delete the 2nd alarm phone numbers:
3.4.3 Change password
Format: [xxxx (new password)] + [*] + [#] + [7]
Description:
phone call controlling or Arming/Disarming the system by keypad on main panel.
The default is "1234"
Example: [6789] + [*] + [#] + [7]
Remark: change the new password to be"6789".
3.4.4 Set ring times before answering the remote calling
Format: [007] + [xx(00-12)] + [##]
Description:
Example: [007] + [03] + [##]
Remark: Set the ring times to be"3". The main panel would answer the phone
call after 3 rings automatically.
3.4.5 Set the sounding time of siren when the alarm is activated
Format: [007] + [xx(00-20)] + [**]
Description:
Example: [007] + [05] + [**]
Remark: Set the sounding time to be"5" minutes when the alarm activated.
3.4.6 Set siren On when the alarm is activated
Format:
[007007] + [##]
3.4.7 Set siren Off when the alarm is activated
Format:
[007007] + [**]
3.4.8 Alarm is activated when the phone line is broken
Format:
[007] + [##]
Description:
would be activated after 35 seconds if the main panel is in arm status.
3.4.9 Alarm is not activated when the phone line is broken
Format: [007] + [**]
3.4.10 Set siren prompt on when arm/disarm
Format:
[009] + [##]
For security, a password is requested to input for remote
The ring times should be set by two digits, from 00 to 12.
The sounding time should be set from 00 to 20 minutes.
If the telephone line is pull out or damaged, the alarm
-- - 32 --