Operation; Record Alarm Voice Message; Enter Setting; Exit Setting - Samba DSD EVOLU 7 Line Guide D'utilisation

1) Connect the siren to AC Adaptor, the siren will sound a beep and the light
flash 1 time, shows connection is successful, and the siren is in working status.
2) Press the black button at the back of the siren for 2s, siren will beep 1 time,
and the light on, shows enter into coding status. Then trigger the
emergency/alarm button on the alarm host, or use remote control to trigger the
alarm to let it send wireless signal., after that the siren will beep 1 time, and also
flash 1 time shows coded successfully.(Siren & Alarm control panel)
3) Then press the black button again for 2s to exit coding status.

3. Operation

3.1 Record alarm voice message

Keep on pressing "Rec" key about 2s to 3s until hear one"Di" beep, then release
the key, the main panel starts to record the voice for 10 seconds. There are two
"Di Di" beeps after it has finished the recording.
Note: the voice message should be short and simple, eg. "This is xxxx(detail
address) , the house is invaded, please help..."

3.2 Enter setting

Press"Rec" lightly, then release the key immediately (no Di sound), the main
panel enters into set mode.

3.3 Exit setting

Press "Rec" again, the device voice two "Di Di" sounds which means the system
has exited set mode. If no any operation in 10 seconds, the system would exit set
mode automatically with two "Di, Di" sounds.

3.4 Setup main panel

Please follow the below steps ( 3.4.1 to 3.4.13 ) to setup the main panel. Before
setup, please make sure it has entered into set mode first according to point 3.2
above, otherwise all the operation is invalid.
The main panel would voice a long "Di" if the current set is successful

3.4.1 Set 6 groups of alarm phone numbers

Format: [xxxxxxxx(phone numbers)] + [*] + [#] + [1(2-6)]
Description: User must set at least 1 valid alarm phone number before using the
main panel, otherwise the main panel would make "Di...Di...Di" alarm beep
every 30 seconds, and it is impossible to dial if the alarm is activated.
Example: [12345678] + [*] + [#] + [1]
Remark: Set the 1st alarm phone number to be "12345678", with the same
method, user could set other 5 alarm phone numbers.
Note:
A) The period between two keypressing is not longer than 10s. The device
would voice a long "Di" sound if the set is successful.
-- - 31 --