Printer; Identification Number; Secret Code; Data-Acquisition - Consort Z621 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

The measured values can be printed automatically at timed intervals or
manually on operator command.
1.
Select the set-up procedure by pressing MODE.
2.
Press CAL until the display shows e.g. [Pt=120]. Select the desired
time interval (0...9999 s) between the transmitted data to a printer,
with
or
. Pre-set to zero if no automatic printing is required.
3.
Press CAL to continue or press MODE to cancel.
The instrument can be identified by e.g. a computer when a specific
number is allocated to it.
1.
Select the set-up procedure by pressing MODE.
2.
Press CAL until the display shows e.g. [Id.no=5]. Select the desired
identification number (0...999) for your meter with
zero if this number should not be mentioned while printing.
3.
Press CAL to continue or press MODE to cancel.
A private code can be programmed to avoid undesired access to the
instrument.
1.
Select the set-up procedure by pressing MODE.
2.
Press CAL until the display shows [Code on], [Code OFF], or [Code
CAL]. Decide, with
calibrations should be by entering a code (on) or not (off). Press CAL
to continue or press MODE to cancel. Select [Code CAL] to enter
your personal code.
3.
The display shows [E=-----] while [=] is blinking. Enter your secret
sequence of 5 keys to proceed. Press CAL to continue or press
MODE to cancel.

DATA-ACQUISITION

Up to 100 values can be stored in the non-volatile memory of the
instrument.
[no LOG]
: No data-logging.
[SEt LOG] : Permits to pre-set the data-logging parameters.
[LSt LOG] : Permits to view the stored values on the display.
[Prt LOG] : Permits to send the stored values to a printer or computer.
[Cnt LOG] : Permits to continue with a next series of measurements,
without erasing the previous data-logging.
or
, whether the access to all future
or
. Pre-set to

Printer

Identification
number

Secret code

4

Publicité

Table des Matières
loading

Table des Matières