Recommended Cutting Equipment For Canada - Jonsered CS 2234S Manuel D'utilisation

Recommended original and replacement bar and chain combinations for USA
Following is a list of recommended cutting equipment for the Jonsered chain saw models CS 2234 and CS 2238. The
combinations of power head, bar and chain have been tested and found to be in accordance with the kickback and
vibration requirements of ANSI B 175.1–2000.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
The following list is the chain saw manufacturers recommendations. There may be other combinations available, which
will also achieve kickback reduction.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our
list. For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy. A hard nose bar having the same length and
nose radius as a sprocket-nose bar may be considered to have equivalent or less kickback energy than the sprocket-
nose bar.
Chain saw models Jonsered CS 2234 and CS 2238 met the kickback performance requirements of ANSI B 175.1-2000
when tested with the combinations of bars and saw chains listed below. The saw chains Oregon 91VG and 90SG are
also classified as a low kickback saw chain since it met the requirements for low kickback saw chain outlined in ANSI
B 175.1-2000. We recommend to use only the listed combinations of bars and chains for chain saw models Jonsered
CS 2234 and CS 2238. Other chain saw models may not meet the kickback requirements when equipped with the
listed bar and chain combinations.

RECOMMENDED CUTTING EQUIPMENT FOR CANADA

The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of
powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw
Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our
list. For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Length, inch Pitch, inch
14 3/8
16 3/8
16 3/8
18 3/8
18 3/8
5451867-95 Rev.3 2008-12-18
TECHNICAL DATA
Bar
Thickness of drive
links, inch/mm
0,050/1,3
0,050/1,3
0,050/1,3
0,050/1,3
0,050/1,3
Max. nose radius Type
7 T H36 / 91VG
7 T H36 / 91VG
7 T Oregon 91VJ
7 T H36 / 91VG
7 T Oregon 91VJ
Chain
Drive link count
52
56
56
62
62
English – 23