Recommended Cutting Equipment For Canada - Jonsered CS2165 EPA II Manuel D'utilisation

Table des Matières

Les langues disponibles

RECOMMENDED CUTTING EQUIPMENT FOR CANADA

The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws.

The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96

Chainsaw Kickback standards.

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding

maximum nose radius of a solid bar.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide

bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be

considered to have equivalent kickback energy.

A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less

kickback energy than the sprocket-nose bar.

We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available

at your dealer.

Bar

Length, inches

Pitch, inch

3/8

Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,

see the table below.

0,050"/1,3 mm

72LP

0,058"/1,5mm

S42/73LP

0,063"/1,6 mm

75LP

WARNING! This chain saw model is capable of severe kickback that

could result in serious injuries to the user. Do not operate this saw

unless you have extraordinary cutting needs and experience and

specialized training for dealing with kickback. Saws with signiﬁcantly

reduced kickback potential are available. Always use the safest saw

and cutting equipment applicable to your cutting need.

TECHNICAL DATA

Chain

Max nose radius

11T