Recommended Cutting Equipment For Canada; Bar And Chain Combinations; Saw Chain Filing And File Gauges - Jonsered CS 2245 Manuel D'utilisation

RECOMMENDED CUTTING EQUIPMENT FOR CANADA

The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of
powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw
Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.

Bar and chain combinations

Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
18 0,325
13 0,325
15 0,325
16 0,325
18 0,325
20 0,325
16 0,325
18 0,325
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below
0,050"/1,3 mm H30
0,058"/1,5 mm -
Saw chain filing and file gauges
40 – English
TECHNICAL DATA
Bar
Thickness of drive
links, inch/mm
1,3
1,5
1,5
- NT 520PS
H25 NT 528PS
Max. nose radius Type
10T
10T
Jonsered H30
10T
10T
10T
10T
10T Jonsered H25
10T
12T
10T
Total NT 528PS
10T
Chain
Drive link count
56
64
66
72
56
64
66
72
80
66
72