Cutting Equipment; Recommended Cutting Equipment - Jonsered 2116 EL Manuel D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

Recommended cutting equipment

The combination of power head, bar and chain used together with this unit has been determined in

accordance with the kickback requirements specified in ANSI B 175.1 - 2000.

The guide bar nose radius is determined either by the maximum number of teeth in the nose

sprocket or by the corresponding maximum nose radius of a solid bar.

The following list specifies the chain saw manufacturer's recommendations. Other combinations may

also provide the same kickback protection.

We have listed the maximum guide bar nose radius, but you may use a guide bar with smaller nose

radius than the one we recommend. For guide bars of the same length, all sprocket-nose guide bars

of the same pitch and having the same number of sprocket teeth may be considered to have equivalent

kickback energy. A hard-nose bar of the same length and nose radius as a sprocket-nose bar may be

considered to have equivalent or less kickback energy than the sprocket-nose bar.

Low kickback saw chain is chain which has met the kickback performance standards of

ANSI B 175.1 and the saftey requirements for gasoline-powered chainsaws when tested on the

representative sample of chain saws below 3.8 cu.in. specified in ANSI B 175.1 These are marked

with an asterisk * in the table below. We recommend that you use the listed bars and chains as

replacements or the low kickback chains available your dealer.

Saw chain

Length

Jonsered H37 *

12, 14 and 16

CSA Z62.3

Recommended Cutting Equipment for Jonsered Electric Chain Saws.

Cutting equipment for class 2A Electric Chain Saws.

Following is a list of evaluated combinations for use on the Jonsered CS 2116 EL chain saw.

These combinations have been determined in accordance with CSA Z62.1-11 Chain Saws and

Z62.3-11 Chain Saw Kickback requirements.

Computed Kickback Angle (CKA) is the angle used as a measure of the reaction of a hand-held

chain saw when subjected, under simulated conditions, to a rotational kickback impulse.

The guide bar nose radius is determined either by the maximum number of teeth in the nose

sprocket or the corresponding maximum nose radius of a solid bar.

As we have listed the maximum guide bar nose radius, you may use a guide bar with a smaller nose

radius than the ones recommended in our list. For guide bars of the same length, all sprocket-nose

guide bars of the same pitch and having the same number of sprocket teeth may be considered to

have equivalent kickback energy.

A hard-nose bar having the same length and nose radius as a sprocket-nose bar may be considered

to have equivalent or less kickback energy than the sprocket-nose bar.

We recommend that you use the listed bars and chains as replacements.

CKA, W/O is the CKA without a chain brake.

CKA, W is the CKA with a chain brake.

Model

Guide bar

h t

inch

CS2116 EL

Other chain and bar combinations may be available which also provide kickback protection.