Introduction; Dear Customer; Symbols On The Machine - Jonsered CS 2234S Manuel D'utilisation

Dear customer!

Congratulations on your choice to buy a Jonsered
product!
Your purchase gives you access to professional help with
repairs and service whenever this may be necessary. If
the retailer who sells your machine is not one of our
authorized dealers, ask for the address of your nearest
servicing dealer.
It is our wish that you will be satisfied with your product
and that it will be your companion for a long time. Think
of this operator's manual as a valuable document. By
following its' content (using, service, maintenance etc)
the life span and the second-hand value of the machine
can be extended. If you ever lend or sell this machine,
make sure that the borrower or buyer gets the operator's
manual, so they will also know how to properly maintain
and use it.
Good luck on using your Jonsered machine!
Jonsered has a policy of continuous product
development and therefore reserves the right to modify
the design and appearance of products without prior
notice.

Symbols on the machine:

WARNING! Chain saws can be
dangerous! Careless or improper
use can result in serious or fatal
injury to the operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator's hands must be
used to operate the chain saw.
Never operate a chain saw holding it
with one hand only.
Contact of the guide bar tip with any
object must be avoided.
6 – English

INTRODUCTION

WARNING! Tip contact may cause the
guide bar to move suddenly upward
and backward (so-called kickback),
which may cause serious injury.
Measured maximum kickback value
without chain brake for the bar and
chain combination on the label.
Other symbols/decals on the machine refer to
special certification requirements for certain
markets.
You will find the following labels on your chain saw:
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirements.
Maintenance, replacement, or repair of the emission
control devices and system may be performed by any
nonroad engine repair establishment or individual.
5451867-95 Rev.3 2008-12-18