Sony CDP-CX350 Mode D'emploi page 23

4
Push the JOG dial.
The track being programmed
PROGRAM1
CD1
DISC TRACK
2 0 3
The disc being
programmed
5
To program other discs/tracks, do the following:
To program
All tracks of another disc(s)
Other tracks on the same disc
Other tracks on other discs
6
Push the JOG dial or press · to start Program
Play.
To cancel Program Play
Press CONTINUE.
The programs remain even after Program Play ends
When you push the JOG dial or press · in Program
Play mode, you can play the same program again.
When you press PROGRAM to select Program Play
during Continuous or Shuffle Play
The program will be played after the current track.
The program remains until erased
Even if you replace discs, the programmed disc and track
numbers remain. Therefore, the player will play the new
existing disc and track numbers. However, the
programed disc and track numbers that are not found in
the player or on the disc are deleted from the program,
and the rest of the program is played in the programmed
order.
You can select the program number (PROGRAM 1,2,
or 3) by using the remote
Press PROGRAM on the remote repeatedly until the
desired program number appears in the display.
Note
If you press one of the GROUP 1 – 8 buttons to start Group
Play, Program Play will be canceled (see page 36).
Checking the programmed order
You can check your program before or after you start
playing.
2 0
Press CHECK.
STEP
1
Each time you press this button, the display shows the
disc and track number of each step in the programmed
order. (When a whole disc is programmed as one step,
Playing order
"ALL" appears instead of the track number.) After the
last step in the program, the display shows "– END –"
and returns to the original display.
Repeat Steps
Changing the programmed order
2 and 4
3 and 4
You can change your program before you start playing.
2 to 4
To
Erase a track or disc
Erase the last track or
disc in the program
Add tracks or discs to the
end of the program
Change the whole
program completely
Erasing the program stored in memory
1
2
Playing CDs Getting Started
You need to
Press CHECK until the track or
disc you don't want appears in
the display, then press CLEAR
Press CLEAR. Each time you
press the button, the last
programmed track or disc will be
cleared.
Follow the programming
procedure
Hold down CLEAR until
"CLEAR" appears in the display
to erase the whole program, then
create a new program following
the programming procedure
Press PROGRAM repeatedly in the stop mode
until the program number (PROGRAM 1, 2, or 3)
you want to erase appears in the display.
Hold down CLEAR until "CLEAR" appears in the
display.
Playing CDs Playing CDs
23 GB