Jacuzzi DESIGNER Série Manuel D'installation page 15

USE & MAIINTENANCE
Functions
TUB
For the models with hydromassage, refer to the "Use and Main-
tenance" manual for the tub.
SHOWER AREA
The following functions are available:
(7) Showerhead, providing different water jet forms and se-
lect these turn the dial to the corresponding symbol.
(5) - (6) Vertical hydromassage, comprising 8 jets, they can
all be used at the same time or in groups of 4.
The form of the jet can be varied by adjusting the dial (
clockwise to obtain a fan jet and anti-clockwise to obtain a con-
centrated jet. The jets can also be adjusted by about 7 degrees
in all four directions.
i
A
(4) Tub filler, located at the bottom of the fixture panel, al-
lowing the tub to be filled.
Instructions for using the taps
• Two functions can be used at the same time: just turn the di-
verter dial halfway between the two symbols (you can hear a
"click").
If, for example, you wish to use all the jets at the same time,
you must turn the dial to the position between the symbols (5)
and (6); naturally, there will be a drop in water pressure and
as a consequence a decrease in the power of individual jets.
• After using the functions we recommend that you turn the di-
verter dial to the "tub filling" position.
• The diverter has a closed outlet (position 8): in this position
no water is supplied.
We recommend that you do not leave the diverter dial in the
closed outlet position, especially if you have a thermostatic
mixer.
Follow these instructions if your Twin Tower/Aulica Twin has:
MODELS WITH SINGLE-CONTROL MIXER (
I
Before using any function, it is advisable to adjust the water
temperature to the desired value by using the tub filler jet as fol-
lows:
I
Turn the diverter dial (1) to the "tub filler" position (4).
I
Pull the lever (3) and turn it to adjust the water temperature.
The maximum temperature of the mixed water must not
exceed 60 °C.
I
Turn the diverter dial to the position you prefer.
I
Remember to turn off the mixer every time after use.
5
i
A):
i
B
Follow these instructions if your Twin Tower/Aulica Twin has:
MODELS WITH THERMOSTATIC MIXER (
I
Turn the knob (3) so that the reference notch matches up with
the pre-selected value. The dial is provided with a stop that fix-
es the temperature at 38 °C; to select higher temperatures,
press the button (3a), to release the dial.
The maximum temperature of the mixed water must not
exceed 60 °C.
I
If you wish to try out the water temperature, turn the diverter
dial (1) to the "tub filler" position (4) and turn the water stop tap
(2) to let out the water.
I
Once the required water temperature has been reached, turn
the diverter dial to the selected position.
I
Every time after use, remember to turn off the water stop tap
(2). If temperatures of over 38 °C have been selected, we rec-
ommend that you turn the thermostatic mixer dial to a position
before the safety lock.
5
i
B)
i
C
15
6
7
4
8
6
7
4
8
1
3
i
C)
1
2
3a
3